NOTE: A small amount ofwaterwillsquirt o utwhen
pressure isreleased.
4. Engage trigger l ockonspray g un when notinuse.
How to Use SprayTips
The
quick-connect
on
the
nozzle
extension
allows
you
to
switch between four different spray tips.The
spray tips vary
the spray pattern as shown (Figure 12).
CAUTION
. NEVER exchange spray tips without Iocldng the safety latch
on the trigger.
Follow these
instructions
to change spray tips:
I.
Engage safety latch on spray gun.
2.
Pull back collar on quick-connect
and pull current
spray tip off. Store spray tips in holder
provided
on the
nozzle extension.
3.
Select desired
spray tip:
•
For gentle
rinse, select white 40 ° spray tip.
•
To scour
surface, select yellow
15 ° or red 0 ° spray
tip.
•
To apply chemical, select black spray tip.
Low Pressure
Black
Use to apply
chemical
40 ° White
High
Pressure
V
ii
m
r
i
i I
I
m
15 ° Yellow
0 ° Red
4.
Pull back on collar, insert new spray tip and release
collar.Tug on spray tip to make sure it is securely
in
place.
5.
For most effective cleaning, keep spray tip from 8 to
24 inches away from cleaning surface. If you get spray
tip too close, you may damage cleaning surface.
6.
DO NOT get closer
than 6 inches when
cleaning tires.
Cleaning
and Applying
Chemical
IMPORTANT:
Use soaps designed
specifically
for
pressure
washers.
Household
detergents
could
damage
the pump.
CAUTION
Starting
the
engine
without
all the
hoses
connected
and
without the water turned ON will damage the pump.
Damage to equipment resulting from failure to follow this
instruction will void warranty.
To apply
detergent
follow
these
steps:
I.
Review spray tip use.
2.
Prepare
detergent
solution
as required
by
manufacturer.
.
Place small filter end of detergent
siphoning
tube into
detergent
container.
CAUTION
. When
inserting
filter into a detergent
solution
bottle, route
tube to keep it from inadvertently
contacting
hot muffler.
4.
Make sure black spray tip is installed.
NOTE:
Detergent
cannot
be applied with the high
pressure
spray tips (White,Yellow,
or Red).
5.
Make sure garden
hose is connected
to water
inlet.
Check that high pressure
hose is connected
to spray
gun and pump and start
engine.
6.
Apply detergent
to a dry surface, starting
at lower
portion
of area to be washed
and work upward,
using
long, even, overlapping
strokes.