Finishing The Installation; Blade Installation - HAMPTON BAY Clarkston El Manual Del Propietario

6.Finishing the Installation

Step 1. Remove 1 of 4 screws on the mounting bracket
and loosen other 3 screws.(Do not remove.) Remove
the motor assembly from J hook .Lift and place the key
holes on the mounting plate over the 3 screws
previously loosened from mounting bracket,turn the
mounting plate until it locks in place and no longer
turns.Secure by tightening the 3 screws previously
loosened and the one previously removed.(Figure 9)
Step 2. Align large screwheads at mounting housing
with slotted holes in the mounting bracket.Turn the
mounting housing until it locks in place and no longer
turns.(Figure 10)
NOTE
YOU MAY THINK THAT YOU HAVE TURNED THE
MOTOR HOUSING ENOUGH UPON FEELING IT
STOP WHEN TURNING IT THE FIRST TIME, BUT
THAT IS PROBABLY ONLY THE HALFWAY POINT
AND IT IS EXTREMELY IMPORTANT THAT YOU
MAKE SURE THAT YOU TURN THE MOTOR
HOUSING ALL THE WAY TO ENSURE THAT THE
MOTOR HOUSING IS COMPLETELY SECURE. TO
DO THIS, WHEN YOU BEGIN TURNING THE
MOTOR HOUSING TWO MORE INCHES (TO THE
LEFT) SO THAT THE SCREWHEADS REACH THE
E N D O F E A C H S L O T T E D H O L E ,
REMAINING SECURE.
Mounting bracket
Washers
Screw
Figure 9
Mounting bracket
T H E R E B Y
Mounting
Housing
Large Screwheads
Figure 10

7.Blade Installation

Step 1. Attach the fan blades to the blade
holders using the blade screws and fiber
washer provided, tighten screws securely.
(Figure 11)
Mounting plate
Step 2. Remove 10 screws from the bottom
motor.Align motor holes to blade bracket
and secure with screws previously removed
from the motor, tighten screws securely.
Repeat procedure with remaining blade
assemblies. (Figure 11)
Figure 11
Screws
Blades
Blade Bracket
Screw
6