Finishing The Installation - HAMPTON BAY Bryant Manual Del Propietário

SUPPLY CIRCUIT
BLACK
ON
WHITE
WHITE BLUE BLACK
Figure 13

Finishing the Installation

Ground
Step 1. Tuck connections neatly into ceiling
Conductor
outlet box.
Outlet Box
Step 2. Remove one screw from the mounting
Green
Ground
bracket and loosen the other screw
Lead
approximately 1/4.
Ground to
Downrod
Step 3. Align the canopy up to ceiling and over
the loosened screw. Place the canopy into key
hole and rotate canopy clockwise. (Figure
14)
Step 4. Secure the canopy by using
previous removed and loosened screws.
Step 5. Place the canopy cover to the
c a n o p y a n d r o t a t e c a n o p y c o v e r
clockwise until it is locked into right
position.(Figure 14)
WARNING
MAKE SURE TAB AT BOTTOM OF HANGER
BRACKET IS HANGER PROPERLY SEATED IN
GROOVE OF HANGER BALL BEFORE
ATTACHING CANOPY TO BRACKET. FAILURE TO
PROPERLY SEAT TAB IN GROOVE COULD CAUSE
DAMAGE TO ELECTRICAL WIRING.
Outlet box
Mounting
bracket
Screw
Figure 14
Screw
Canopy
Canopy Cover
6