General Parameters - Honeywell Home EW600 Serie Traducción Del Manual De Servicio Y Montaje

General parameters

Next due date
Activate / deactivate levels
Change the dimensioning unit
(kWh ↔ MWh or MJ ↔ GJ)
Switch the checksum display on / off
(postcard readout)
Additional parameters for devices with impulse inputs EW6001BK...
"Pi. and EF" appears if a meter with a device
number has not been able to be assigned to the
impulse inputs
grammed meter number appears.
Serial number of the external meters
Reset meter number
You can reset the meter number for
"0" as the meter number. "Pi. and EF" appears in the display again for a free
impulse input.
When meter numbers are reset, all the meter impulses counted up to
this point are reset and deleted permanently.
Starting counting statuses of the external meters
Changing the dimensioning unit (L ↔ )
Adapting the filter
= No reduction of the scanning rate
= Reduction of the scanning rate
Impulse values of the external meters
(10 L/Imp ↔ 1 L/Imp)
Medium can be chosen from water or hot water
Do not activate
pulse, because the impulse is not taken into account by the calculator
unit.
EN 40 MU2H-0491ge23 R1020
or yet. Otherwise the pro-
for water meters greater than Qn 4 with 1 L/im-
Level
L3
L3
L3
L3
L3
L3
and by programming an 8-digit
L3
L3
Display