Troubleshooting; Declaration Of Conformity - oneConcept 10009441 Manual Del Usuario

Problem Possible cause
Spin Tub stops No electricity.
spinning.
Electrical plug is loose.
Timer has already reached zero.
Upper cover Is not closed.
Excessive vibration. Clothes are not arranged evenly.
Clothes are stuck in between the inner
and outer tub.
Flooring is not even.
Slow Spinning. Machine is overloaded.
Water accumulates in the tub because
drain hose is not placed on the floor.
Noise during Clothes is jumping up out of the tub.
spinning.
Water is not The drain hose Is elevated.
Draining properly.
Something is blocking the drain hose.
Something is stuck in the outer tub.
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany.
This product is conform to the following European Directives:
2014/30/EU (EMC)
2014/35/EU (LVD)
2011/65/EU (RoHS)

Troubleshooting

Declaration of Conformity

Solution
Check the power supply.
Check that the plug is inserted properly.
Set the timer to preferred time.
Close the cover.
Rearrange the clothes in the tub.
Remove the clothes.
Move the machine to another location
with even flooring.
Reduce some of the clothes.
Put down the drain hose.
Place the safety cover before Use.
Lower the drain hose to floor Level.
Remove the obstruction.
Check outer tub and remove obstruction.
7