English
Accepting door calls
The ringing tones for the front
door and apartment door are dif-
ferent. When a visitor presses the
door bell, the telephone rings and
the mute button flashes.
The visitor's image can be seen on
the monitor. Using the zoom func-
tion, an excerpt of the picture can
be enlarged.
The call can be accepted within 1
minute of the last ring tone.
Actuating the door release
When you press the door release
button, the door from which the
last call came is opened for 3
seconds.
Switching on the light
When you press the light button,
the lighting is switched on, pro-
vided this has been connected by
your electrical installer.
Muting the bell
When the mute button is pressed
briefly, all the ringing tones are
switched off or on again. The
button lights up red to indicate
that the mute has been activated.
If a visitor rings the door bell while
the in-house telephone is switched
to mute, the button flashes.
Ring tone volume
The ring tone volume can be
changed using a potentiometer
below the lettering field.
(see page 33)
Key assignment
The function of the buttons
depends on how the telephone
has been configured. For further
information, please contact your
electrical installer.
Video memory
The Multi Telephone with colour
monitor is equipped with a video
memory. The video memory is only
functional if activated by your elec-
trical installer. All visitor pictures
are saved with a date and time. Up
to 28 pictures can be saved in the
device. Once the memory capacity
has been used up, the oldest
picture is overwritten each time a
new picture is taken. After a power
cut, pictures saved in the in-house
telephone are deleted.
Assigning the monitor buttons
The monitor is operated using a
5-way button. The Enter key is
used to switch on the monitor or
confirm a selected function. The
control buttons are used for navi-
gation within the different menu
levels.
Enter button
The control buttons can be
assigned with different functions
depending on the monitor display.
The functions of the buttons are
indicated by a display superim-
posed at the bottom edge of the
monitor.
SD card
At the top of the unit, an addi-
tional SD card can be inserted.
Cards ranging in size from
32 MB to 32 GB can be used,
with capacity for storing between
25 and over 20000 images
depending on the size. One image
requires around 1,2 MB of storage
space. The images are saved in
*.tif format with a resolution of
720 x 576 Pixel.When the card's
memory is full, the oldest image
is always overwritten. If the card
is inserted, the SD card symbol is
shown in the upper line.
Control buttons
5