HoMedics PA-4H Manual De Instrucciones Y Garantía página 3

PA-4H 2/10/06 4:34 PM Page 5
Instructions for Use
This appliance has a polarized plug (one blade is wider than the other). This
plug will fit in a polarized outlet only one way. If the plug does not fit fully in
the outlet, reverse the plug. If it still does not fit, contact a qualified elec-
trician to install the proper outlet. Do not change the plug in any way.
1. The Programmable Percussion Massager is powered by and comes with
a UL-approved cord. Untie cord strap, extend cord and insert plug into
120-volt household electrical outlet to power unit.
2. To turn unit on, press POWER button located above foam-cushioned
handle. A corresponding LED light will illuminate to indicate all
selections. (See Figure 1.)
3. Choose the desired massage option: steady or program.
4. For steady massage, press MASSAGE button. To increase or
decrease the massage intensity level, press the up or down arrows on
each side of the PROGRAM button. The intensity level is indicated by
the LED lights in the center of the program panel.
5. For a programmed massage, press the PROGRAM button on the
upper left side. Choose any of the three program options:
• P1 provides slow, steady percussion action to relax and revitalize.
• P2 provides intense massage action to penetrate and soothe.
• P3 provides short, quick bursts for energizing stimulation.
An interval level may be chosen by pressing the INTERVAL button on
the upper right side. There are three interval options: I1 (low), I2
(moderate) and I3 (high).
6. Gently apply massage heads to the area you wish to treat, and move
slowly in a circular motion.
4
7. Treat the target area for a short period of time, and then move to
another area. Never treat the same area longer than 3 minutes.
CAUTION: As stated in the "IMPORTANT SAFETY
INSTRUCTIONS" section of this manual, never use this appliance
on or near the eyes, temples or other highly sensitive areas.
8. A massage session of longer than 20 minutes is not
recommended.
9. When treatment is completed, turn the unit off and unplug the
power supply. Store the unit properly in a cool, dry place,
Figure 1
preferably in its original packaging.
To Change Attachments
Programs: Your massager comes with 4 custom massage head attachments.
Each set is a different firmness:
• Hard (light grey)
P1
• Soft (black)
To remove the massage heads from the unit, rotate each counter-
P2
clockwise. Rotate clockwise to fasten the massage heads. (See Figure 3.)
P3
Figure 3
• Medium (medium grey)
• Heat (red)
5