Selecting The Direction Of Rotation - Famastil F-POWER Manual De Instrucciones

To charge the battery, make sure it is
01
connected to the charger base (PIC 3).
Plug the charger to the base. Plug it to
02
the power.
03
The red light on the charger base
indicates that the load is happening
(PIC 4).
After normal use, a charging time of 3
hours will provide sufficient power for
most applications. However, further
charging for up to 5 hours could
significantly increase the use time,
depending on the battery and charging
conditions.
WARNING! Do not leave the battery
charging for more than 10 hours.
This can damage it and cause
accidents.
04
Disconnect the tool from the charger.
DIRECTION
SELECTOR
28
BATTERY CHARGER BASE
GREEN LED:
WAITING
RED LED:
CHARGING

SELECTING THE DIRECTION OF ROTATION

PIC 5
For drilling and for tightening screws,
use forward (clockwise) rotation. For
loosening screws or removing a jammed
drill bit, use reverse (counterclockwise)
rotation.
01 To select forward rotation, push the
direction selector to the left (PIC 5).
02 To select reverse rotation, push the
direction selector to the right (PIC 5).
To lock the tool, set the direction selector
into the centre position.
PIC 3
BATTERY
PIC 4