Double Speed; Hints For Optimum Use; Maintenance - Famastil F-POWER Manual De Instrucciones

DOUBLE SPEED (PIC 9)
The dual speed function gives
to the user the ability to set the
maximum speed to be achieved by
the screwdriver. The speed I will have
higher torque and less rpm, as speed II
gives a greater number of rotations, but
with a reduced torque capacity.
DRILLING
• Always apply a light pressure in a
straight line with the drill bit.
• Just before the drill tip breaks through
the other side of the workpiece,
decrease pressure on the tool.
• Use a block of wood to back up
workpieces that may splinter.
• Use spade bits when drilling large
diameter holes in wood.
Your Famastil F-POWER tool has been designed to operate over a long period of time
with a minimum of maintenance. Continuous satisfactory operation depends upon
proper tool care and regular cleaning. Your charger does not require any maintenance
apart from regular cleaning.
WARNING! Before performing any maintenance on the tool, remove
the battery from the tool. Unplug the charger before cleaning it.
• Regularly clean the ventilation slots in your tool and charger using a soft brush or
dry cloth.
• Regularly clean the motor housing using a damp cloth. Do not use any abrasive or
solvent-based cleaner.
30

HINTS FOR OPTIMUM USE

MAINTENANCE

SPEED II
SCREWDRIVING
• Always use the correct type and size of
screwdriver bit.
• If screws are difficult to tighten, try
applying a small amount of washing
liquid or soap as a lubricant.
• Always hold the tool and screwdriver
bit in a straight line with the screw.
PIC 9
SPEED I