Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ABOUT THE CODES
F
– The F code means your unit is empty and needs to be FILLED with water.
CL
– Your CONTROLS ARE LOCKED on the current setting. Activate the control lock by holding the power button for five
seconds, until CL appears. Your Horizon will lock on the current fan and humidity settings. Release the lock by pressing the
power button again for five seconds until the display flashes CL twice, letting you know the lock is off.
CF
– The CF code triggers after 720 hours of use and means it's time to CHECK YOUR FILTER (wick). Unplug your unit and
check your wicks. If your wicks are still in good shape, simply clear the code by plugging your humidifier back in. If your wicks
needs replacing, install new HDC411 Super Wicks®.
5
9
Plug in your unit and press the power
button
10
10
Set your desired fan speed by pressing
the fan speed button . Your Horizon
11
has three fan speeds that are displayed by
F1 (the lowest speed) through F3 (the highest
speed).
9
Note: On higher speeds, the Horizon puts out a tremendous
amount of humidity, so it's louder on these levels. Most of our
customers liken it to the sound of a box fan. Rest assured there is
nothing wrong with your unit, it's just working very hard to put out
much-needed humidity.
11
Press the humidity control button
to set your humidity level from 25% to
65%. The humidistat on your cord will read your
home's humidity and turn your fan off when the
set level is reached. When set to 65%, your unit
will run continuously.
That's it! Your Horizon is ready to use.
.
Publicidad
Tabla de contenido
