Aircare MINI-CONSOLE 5D6700 Serie Manual Del Usuario página 4

ABOUT THE CODES
CL – Your CONTROLS ARE LOCKED on the current setting. Activate the control lock by holding the power button for five
seconds, until CL appears. Your Mini-Console will lock on the current fan and humidity settings. Release the lock by pressing
the power button again for five seconds until the display flashes CL three times, letting you know the lock is off.
CF – The CF code triggers after 720 hours of use and means it's time to CHECK YOUR FILTER (wick). Unplug your unit and
check your wicks. If your wicks are still in good shape, simply clear the code by plugging your humidifier back in. If your wicks
need replacing, follow these quick steps:
1. Remove the fan assembly from the cabinet.
2. Remove the wick platform. Do not discard the platform.
3. Replace the old wicks with new 1040 Super Wicks®.
4. Reassemble the unit.
9
Press the fan button again to select your
desired fan speed. Your Mini-Console
has four fan speeds that are displayed by F1 (the
lowest speed) through F4 (the highest speed). F0
indicates your Mini-Console is in standby mode.
10
Press the humidity control button
to set your humidity level from 25% to
65%. The humidistat on your cord will read your
home's humidity and turn your fan off when the
set level is reached. When set to 65%, your unit
will run continuously.
That's it! Your Mini-Console is ready to use.
HOW TO CLEAN YOUR MINI-CONSOLE
Regular cleaning is important for preventing mold,
mildew, and other bacterial growth in your humidifier.
It also keeps your Mini-Console working its best.
1. Let the unit run until it's empty, then turn it off and
unplug it.
2. Remove the fan assembly, wick platform (do not throw
this away), and the wicks. Throw your wicks away if it
is time to replace them. Otherwise, put them in a sink
while you finish cleaning your Mini-Console.
3. Pour out any remaining water from the cabinet.
4. Fill the cabinet half-full with water and add 1 cup of
white vinegar. Let sit for 20 minutes. To disinfect,
replace the vinegar with 1 teaspoon of bleach. Do not
mix vinegar and bleach.
5. After 20 minutes, empty the cabinet.
6. Dampen a sponge with white vinegar, wipe down
the cabinet and wick platform, then rinse everything
thoroughly. To disinfect, replace the vinegar with
bleach.
7. Wipe everything dry and replace the wick, if needed.
Then reassemble.
When storing your Mini-Console, discard the used wicks (keep
your wick platform) and disinfect the unit using the directions
above. Dry the unit thoroughly, and store in a temperature-
regulated area. Do not install new wicks until you are ready to
use your humidifier again.
6