User Manual
EN
4 port USB 2.0 Hi Speed HUB
1 Safety instructions
The user manual is part of the product and contains important information for
correct use.
• Read the user manual completely and carefully before use.
The user manual must be available for uncertainties and passing the product.
• Keep this user manual.
Notes for network separation
The product has no power switch and may be used only in easily accessible
outlets to quickly remove it in an emergency and after use.
Voltage-free only with pulled plug.
• In case of emergency, during thunderstorms and after use, pull the pro-
duct on its plug housing! In case of emergency, during thunderstorms and
after use, pull the product on its plug housing!
• Do not open the housing.
• Do not modify product and accessories.
• Do not short-circuit connectors and circuits.
A defective device may not be put into operation, but must be disconnected
from mains and protected against further use.
• Use product, product parts and accessories only in perfect condition.
• Avoid stresses such as heat and cold, moisture and direct sunlight, micro-
waves, vibrations and mechanical pressure.
• In case of questions, defects, mechanical damage, trouble and other pro-
blems, non-recoverable by the documentation, contact your dealer or pro-
ducer.
Not meant for children. The product is not a toy!
• Secure packaging, small parts and insulation against accidental use.
2 Description and function
2.1 Product
This product is a USB 2.0 splitter to which up to 4 USB devices can be con-
nected via a USB socket. It is used for data transfer and interface expansion
of your computer.
2.2 Scope of delivery
4 port USB 2.0 Hi Speed HUB, Power supply unit, Connection cable,
User Manual
2.3 Operating Elements
1 DC socket
4 Power supply unit
2 USB input
5 Euro plug
3 USB outputs
6 DC plug
2.4 Specifications
Article number
Connectors - Inputs
Connectors - Outputs
Input
Max. data transmission rate
Dimensions
Weight
Power supply unit
Connectors
Input
Output
Average active efficiency
No-load power
consumption
REV2021-04-28
Subject to change without
V1.0aw
notice.
7 USB-A 2.0 plug
8 USB-B 2.0 mini plug
95912
USB-A 2.0 socket, DC socket
4x USB-A 2.0 socket
5.0 V
, 2.0 A max.
480 MBit/s
32 x 73.3 x 10 mm
21 g
Euro plug (type C, CEE 7/16),
DC plug (3.5 x 1.35 mm)
100-240 V
, 50/60 Hz, 0.35 A max.
5.0 V
, 2.0 A, 10.0 W
82 %
0.05 W
Dimensions
Weight
Cable length
Connection cable
Connectors
Cable length
Weight
3 Intended use
We do not permit using the device in other ways like described in
chapter „Description and Function" or in the „Safety Instructions".
Use the product only in dry interior rooms. Not attending to these
regulations and safety instructions might cause fatal accidents, injuries, and
damages to persons and property.
4 Preparation
1. Check the scope of delivery for completeness and integrity.
2. Compare the specifications of all used devices to ensure compatibility.
5 Connection and operation
1. Connect the DC plug of the power supply unit to the DC socket of the
HUB.
2. Connect the USB input of the HUB to your PC via the connection cable.
3. Connect up to four USB end devices to the USB outputs of the HUB using
appropriate USB cables.
4. Disconnect all cable connections after use.
6 Maintenance, Care, Storage and Transportation
The product is maintenance-free.
NOTICE!
• Always unplug the power cord before cleaning.
• Only use a dry and soft cloth for cleaning.
• Do not use detergents or chemicals.
• Store the product out the reach of children and in a dry and dust-protected
ambience when not in use.
• Store cool and dry.
• Keep and use the original packaging for transport.
7 Disposal instructions
According to the European WEEE directive, electrical and electronic
equipment must not be disposed with consumers waste. Its
components must be recycled or disposed apart from each other.
Otherwise contaminative and hazardous substances can damage
the health and pollute the environment.
As a consumer, you are committed by law to dispose electrical and electronic
devices to the producer, the dealer, or public collecting points at the end of
the devices lifetime for free. Particulars are regulated in national right. The
symbol on the product, in the user manual, or at the packaging alludes to
these terms. With this kind of waste separation, application, and waste
disposal of used devices you achieve an important share to environmental
protection.
WEEE No: 82898622
8 Symbols used
For indoor use only
Alternating current
Direct current
- 2 -
Pillmanstraße 12 | 38112 Braunschweig | Germany
95912
90 x 40 x 67 mm
91.5 g
1.2 m
USB-A 2.0 plug,
USB-B 2.0 mini plug
0.4 m
15 g
Material damage
IEC 60417- 5957
IEC 60417- 5032
IEC 60417- 5031
Goobay® by Wentronic GmbH