Warranty, Parts List, Troubleshooting Guide - Zuvo 100 Serie Manual Del Usuario

Warranty
The Zuvo Water Filtration System has a one (1) year limited
warranty to the original user, to be free from defect in
material and workmanship, from the date of purchase. This
unit is designed for non-commercial applications. Use in
commercial applications will void this product warranty.
Supplier liability under this warranty is strictly limited to
repairing or replacing (at supplier's option), without charge,
FOB supplier's authorized service facility, the unit or units.
Both Zuvo Water and your supplier will not be held liable
for any costs of removal, installation, transportation to an
authorized service center, or any other charges which may
arise in connection with a warranty. Both Zuvo Water and
your supplier will not be held liable for damage or wear to
products caused by abnormal operating conditions, accident,
abuse, misuse, unauthorized alteration or repair, or if the unit
was not installed in accordance with printed installation and
operating instructions.
This warranty does not cover replacement filters.
Replacement of lamp assemblies is limited to a period of
one (1) year from the date of purchase.
Zuvo Water and your supplier will assume no responsibility
for any incidental or consequential damages, losses, or
expenses arising from installation, use, or any other causes.
There are no express or implied warranties, including
merchantability or fitness for a particular purpose, which
extend beyond those warranties described or referred to above.
Some jurisdictions do not allow the exclusion of incidental or
consequential damages, and some jurisdictions do not allow
limitations on how long implied warranties may last.
Therefore, the above limitations may not apply to you. This
warranty gives you specific legal rights, which vary from
jurisdiction to jurisdiction.
Troubleshooting Guide
WARNING
UNPLUG CORD FROM ELECTRICAL OUTLET BEFORE SERVICING
PROBLEM POSSIBLE SOURCE
Tubing not securely
UNIT LEAKING
connected and/or tubing
AT TUBING
lock ring not secured
CONNECTION(S)
over tubing fitting
UNIT LEAKS AROUND
TOP CAP AFTER O-ring on top is not
FILTER HAS BEEN properly seated
REPLACED
WATER IS FLOWING
Filter element, diverter
FROM THE UNIT AT A
screen, and/or inlet
VERY SLOW RATE
clogged
• No power
LAMP NOT LIT WHILE
UNIT IS RUNNING
• Lamp burned out
BUBBLES ARE NOT
• Filter is exhausted
VISIBLE WHILE UNIT
• Inlet tubing kinked
IS RUNNING
AREAS TO CHECK
Verify that tubing is properly
connected and that the lock ring
is engaged
Verify O-ring is seated
• Replace filter
• Remove diverter valve from
the faucet and clean screen
(countertop installation only)
• Reverse flow to unit temporarily
to remove blockage. This can
be done by temporarily reversing
inlet and outlet fittings
• Unit not plugged in properly
• Replace lamp
• Replace filter
• Reverse tubing
Parts List
To assist you in identifying components of your Zuvo Water
Filtration System, the parts have been numbered as follows:
1 Top Cap
2 Sealing Clamps
3 UV Lamp
4 Water Reservoir (blue)
5 Lamp Replacement / Tubing Disconnect Tool
(spanner wrench and screwdriver)
6 Filter (supplied inside the unit)
2
3
5
1
2
4
6
Page 3