Assembly And Installation - Philips SDV4310/27 Manual De Instrucciones

4.1 Assembly and installation
Attach the two piece reflectors together
1
using four bolts and wing nuts provided.
Note
D
Be sure wing nuts are on outside of the
reflector.
1
Extend the folded drive element by carefully
2
folding the "wings" outward so they are at
90 degrees to the boom. Then place the
unattached end over the lead-in terminal.
Attach Transformer to bottom studs of drive
3
elements with wing nuts and washers.
Slide the reflector screen onto the boom
4
from the rear until the screw holes of the
screen bracket line up with the holes on
the top and bottom of the boom.
Attach the screen to the boom using two
(2) 1-1/2" bolts, lockwashers and wing nuts.
E Tip
To make the fit easier when sliding the screen
onto the boom, squeeze the top and bottom of
the screen toward each other.
Insert end caps at end of boom.
5
Attach the antenna to the mast: Assemble
6
U-bolt to cross piece. Attach U-bolt
assembly loosely to antenna, using saddle,
lockwashers and nuts. Insert mast through
U-bolt. Tighten nuts securely.
Connect 2 mast sections as shown.
7
2
3
4
4
5
Lead-in terminal
Washers
Transformer
Cross Piece
Assembled
Antenna
Saddle
Nut
Lockwasher
1
2
Folded
drive
element
3
Lead-in terminal
Wing Nut
4
U-Bolt
End Cap
Mast
5
5