Sony SU-XWQ005 Guia Del Usuario página 8

Step 3: Install the Plate
Unit on the wall
1
Attach the Plate Unit to the wall
using at least six M8 (or
equivalent) screws (not
supplied).
Select at least six screw holes with the same
mark shown in the diagram below, and tighten
the screws securely so that they will not come
loose.
WARNING
• The screws securing the Wall-Mount Bracket
to the wall are not supplied. Be sure to use
the appropriate screws, depending on the
material and structure of the wall.
• If the Plate Unit cannot be attached securely
enough, use additional screws.
• Be sure to confirm that the Plate Unit is
securely attached to the wall.
Align the unit so that it is exactly level.
Plate Unit
6
(US)
2
Adjust the angle of the arms.
When installing the Display Unit
perpendicularly (0 degrees), adjustment of the
arms angle (Procedure 1 and 2 below) is not
necessary. Make sure that each arm base is
screwed in securely.
1 Remove the screws from the top and bottom
center of the both arm bases. Then choose the
notch corresponding to the desired angle
(5, 10, 15 or 20 degrees) and fit the arm base
to it.
2 Firmly secure each arm base using the screws
removed in the above procedure 1.
Notes
• Be sure to adjust the angle of both left and right
arms to the same angle.
• Be careful not to get your fingers caught when
adjusting the angle of the arms.
• When using an electric screwdriver, set the torque
setting to approximately 2 N·m.
• Make sure that the two Mounting Hook Unit
support shafts on the lower part of the Plate Unit
are screwed in securely.
• 0 degrees: Leave the white screws tightened as
they are.
• Other than 0 degrees: Remove the white screws.
1
Mounting Hook Unit
Support Shaft
Arm Base
2