Famastil TICO-TICO Manual De Instrucciones página 18

11 Avoid accidental starting. Ensure
the switch is in the off position before
plugging in. Carrying power tools with
your finger on the switch or plugging
in power tools that have the switch on
invites accidents.
12
Remove any adjusting key or wrench
before turning the power tool on. A
wrench or a key left attached to a
rotating part of the power tool may
result in personal injury.
Do not overreach. Keep proper footing
13
and balance at all times. This enables
better control of the power tool in
unexpected situations.
14 Dress properly. Do not wear loose
clothing or jewellery. Keep your hair,
clothing and gloves away from moving
parts. Loose clothes, jewellery or long
hair can be caught in moving parts.
POWER TOOL USE AND CARE
Do not force the power tool. Use the
15
correct power tool for your application.
The correct power tool will do the job
better and safer at the rate for which it
was designed.
Do not use the power tool if the switch
16
does not turn it on and off. Any power
tool that cannot be controlled with
the switch is dangerous and must be
repaired.
17 Disconnect the plug from the power
source before making any adjustments,
changing accessories, or storing power
tools. Such preventive safety measures
reduce the risk of starting the power
tool accidentally.
18 Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands
of untrained users.
18
19 Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any other
condition that may affect the power
tools operation. If damaged, have
the power tool repaired before use.
Many accidents are caused by poorly
maintained power tools.
20
Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely
to bind and are easier to control.
For operations different from those
intended could result in a hazardous
situation.
21 Use the power tool, accessories
and tool bits etc., in accordance with
these instructions and in the manner
intended for the particular type of
power tool, taking into account the
working conditions and the work to
be performed. Use of the power tool
for operations different from those
intended could result in a hazardous
situation.
SERVICE
22
Have your power tool serviced only by
F-Power authorized service center using
only original replacement parts. This will
ensure that the safety of the power tool
is maintained.
ELECTRIC SECURITY
This tool is double insulated;therefore
23
no earth wire is required.
24 Always check that the power supply
corresponds to the voltage on the rating
plate.