Famastil TICO-TICO Manual De Instrucciones página 22

TO RESET THE SHOE PLATE (4) FOR STRAIGHT CUTS:
Loosen the screw. Rotate the shoe plate until the slot in the shoe plate reaches the 0°
position, then push the shoe plate forwards. Tighten the screw.
SWITCHING ON AND OFF (PIC 5)
01
To switch the tool on, press the on/off
switch.
02 To switch the tool off, re lease the on/off
switch.
For continuous operation, press the
03
lock-on button (2) and release the on/off
switch.
To switch the tool off when in
04
continuous operation, press and release
the on/off switch.
TRAVA
SAWING
Let the blade run freely for a few seconds before starting the cut.
01
Apply only a gentle pressure to the tool while performing the cut.
02
SAWING METAL
Be aware that sawing metal takes much more time than sawing wood. Use a saw blade
suitable for sawing metal. When cutting thin sheet metal, clamp a piece of scrap wood
to the back surface of the workpiece and cut through this sandwich. Spread a film of oil
along the intended line of cut.
22
PIC 5
HINTS FOR OPTIMUM USE
VARIABLE SPEED ADJUST BUTTON (PIC 6)
The "variable speed adjust button"
allow configure the movement of the Jig
Saw blade when using the tool.
Turn the variable Speed adjust button
01
to the number "6" to reach the maximum
speed of the blade.
02
Turn the variable Speed adjust button to
the number "1" to reduce the speed of the
blade.
PIC 6