Remington KF40E Manual Del Usuario página 4

ENGLISH
• Do not twist or kink the cable, or wrap it round the appliance.
• Do not use the appliance if it is damaged or malfunctions.
• Check the cord regularly for any sign damage.
• Always keep the lid closed while the rollers are heating.
• Ensure there is a roller on each slot while the unit is heating and that each roller is
properly inserted into the base unit.
• DO NOT USE ON ARTIFICAL HAIRPIECES OR WIGS.
• This appliance is not intended for commercial or salon use.
PARTS
1. Velvety flocked rollers
4 x 19mm
10 x 21mm
6 x 26mm
2. Built in easy clips
INSTRUCTIONS FOR USE
• Before setting, hair should be dry or slightly damp, never wet.
• Section hair and comb it smooth.
• Plug the product into the mains power supply.
• The lid should be in the down position until the rollers are ready to use.
• The rollers will start to heat up in 3 minutes. Allow 10 minutes for them to reach the
optimal curling temperature.
• When you feel your setters are ready, open the lid for 1 minute and begin use.
• Select the desired size of roller. Use the small rollers for tighter curls; the larger rollers
give looser curls and waves.
• Take a section of hair, about the width of the roller.
• Squeeze the starter clip open and clamp onto the tip of a section of hair.
• Wind the roller right down to the roots.
• Secure the roller firmly in place with the comfort clip.
• Leave all the rollers in the hair until the rollers and hair have fully cooled down and set
the style.
• Note: Use fixing spray to help set and keep your style for longer
• Remove the rollers from your hair by removing each clip and gently unwinding.
• Let the curl spring back into place and leave the hair to cool fully before styling to
ensure the optimum set.
• Unplug the unit after you have used all the rollers you need.
4
3. On indicator light
4. Comfort clips
5. Cool touch end
6. Base unit