Loading Data - RCBS 87006 Instrucciones Del Producto

• Stay alert. Reload only when you can give your undivided attention. Do not reload when tired, ill, rushed
or under the influence of drugs or alcohol.
Because RCBS
other reloading equipment, RCBS assumes no liability, expressed or implied, for the
PRIMER AND POWDER WARNINGS
DANGER! DO NOT TUMBLE/CLEAN CARTRIDGE CASES OR AMMUNITION CONTAINING LIVE
PRIMERS AND/OR POWDER.
The action of the Rotary Case Cleaner can break down the structure of the powder kernels and
priming mix. This may lead to an unsafe ignition of the cartridge or possible misfire.

LOADING DATA

• Use only laboratory tested reloading data. We highly recommend the current SPEER Reloading Manual.
OBSERVE ALL WARNINGS ABOUT THE USE OF MAXIMUM LISTED LOADS.
WORKING WITH CARTRIDGE CASES
• Examine empty cases to be sure they are in good condition before reloading. Thin, split, deformed,
or badly corroded or pitted cases may be structurally weak, and result in a dangerous condition. Pay
particular attention to splits in the mouth, separation between the case and the head, and dents in the
shoulder.
• Do not store cartridge cases or ammunition near harsh chemicals such as gasoline, household cleaners
or cat urine. The fumes can weaken the metal and present a dangerous condition.
• Do not clean cases with chemicals other than those specifically designed for the purpose.
• Do not attempt to clean loaded ammunition or primed cases. Doing so can cause corrosion, and weaken
the case, or cause a misfire/hangfire condition.
• Ensure cases have proper primer pocket sizes; remove primer staking/crimp if necessary. Attempting to
seat a primer into an undersized pocket or pocket with staking/crimping can result in detonation.
• Do not ream out or enlarge flash holes of cartridge cases. This may change the ignition rate and result
in dangerous pressures.
• Resize and trim fired cases to ensure reliable chambering and obtain proper bullet tension and crimp.
• Never attempt to guess at the identity of your ammunition.
ELECTRICAL WARNINGS
WARNING: CARE SHOULD BE USED WHEN OPERATING ELECTRICAL APPLIANCES IN WET
AREAS OR AROUND WATER. ALWAYS UNPLUG UNIT WHEN FILLING OR DRAINING TANK.
OPERATING UNIT ON A GFCI OUTLET WITH A RATED TRIP CURRENT OF NO MORE THAN 30mA
IS RECOMMENDED TO PROVIDE PROTECTION AGAINST ELECTRIC SHOCK. THE INSTALLATION
OF A GFCI CIRCUIT SHOULD ONLY BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
CAUTION: Leave the unit unplugged until you have read all the instructions and are ready to
use.
has no control over the choice, assembly or use of components or
®
use of ammunition reloaded with this product.
4