Uline H-1250 Manual De Instrucciones

H-1250
FOOT-OPERATED
IMPULSE SEALER
1. Read all instructions before use and save these
instruction for later use.
2. Follow all warnings and instructions marked on
the product.
3. Unplug this product from the power source before
cleaning and/or changing any parts.
4. Do not rest anything on the power cord. Do not
place the machine where the power cord may be
stepped on or pulled.
5. Always keep out of reach of children and pets.
6. This sealer should only be in use with an operator in
attendance.
7. Never insert clothing, hand or fingers between the
sealing jaws of sealers or into the feed opening of
continuous sealers.
8. Never touch the heating elements with bare hands
while the sealer is plugged into a power source, in
operation, or just finished operation. It is HOT.
9. Be sure to check for worn parts before starting
operation.
Page 1 of 9
1-800-295-5510
uline.com
SAFETY
Pour le français, consulter les pages 7-9.
WARNING! Never connect the sealer's
power cord to outlet during assembly.
10. Do not operate with a damaged power cord or plug.
11. Always keep the unit clean. Do not use water.
Silicone spray may be used to clean the unit. Be
sure the unit is unplugged from the power source
before cleaning.
12. When changing blade (for sealer with cutter), be
careful of the sharp edge.
13. When changing the Teflon adhesive, be sure that
the entire surface under the heating element is
covered with Teflon adhesive. Bend down the excess
Teflon adhesive on both ends. This will prevent the
heating element from breaking and the machine
from grounding.
14. When replacing fuse, be sure the exact voltage and
ampere is used.
15. Be sure to keep a record of your model number.
Specify this number when ordering
16. When replacing any parts, be sure to mark down the
exact locations of the connections, and the orders
of the different pieces.
Para Español, vea páginas 4-6.
0421 IH-1250