Balluff BTL7-S510 Serie Manual página 24

BTL7-S510(B)-... / BTL7-S5 _ _ C-... / BTL7-S5 _ _ D-...
BTL7 Configuration Tool
3
Windows and tabs (continued)
3.2.2 BTL information
The following BTL information is displayed:
– Type
– Serial number
– Firmware version
– Nominal length of the connected BTL
– Output: SSI
3.2.3 SSI status
Clock period Display of the SSI clock period T
E.g. 2.00 µs (500 kHz) or SSI clock frequency f
If an SSI communication error
(T
Communication error
If synchronous operation is active in
the BTL
Synchronization
If the current position value has
been queried via the SSI interface
Active
3.2.4 Connection
BTL is connected.
BTL is not connected.
3.2.5 Menu bar
The menu bar contains the menu commands. The menu
commands are described in Section 4 "Menus" starting on
page 13.
3.2.6 Update BTL
Changed values for a configuration are indicated in the
BTL7 Configuration Tool by blue numbers and letters and
the U button is active.
pdate btl
Clicking on U sends the information to the BTL.
pdate btl
Transmission takes a certain amount of time, since all the
parameters are sent.
The U button is only active if there are
pdate btl
changed settings pending.
8 english
CLK
CLK
or T event) has occurred
o m
3.2.7 Tabs
Settings are made on the tabs.
Magnet:
– Select number of magnets.
– Online display of the configuration.
Output: function, number of bits, coding, upper/lower
limits, scaling, and error value can be selected and the
curve can be adjusted.
Advanced settings:
The operating mode of the SSI interface (synchronous/
asynchronous operation), noise filter, and average filter can
be set.
The following sections describe the tab elements and how
to make or change settings.