Fan Assembly. Pgs - Craftmade Kate Guia De Instalacion

5. Fan Assembly.
Remove hanging ball from downrod provided
by loosening set screw on hanging ball. Remove
pin and clip. Lower hanging ball and remove
stop pin. Then slide hanging ball off downrod.
[Refer to diagram 1.]
Loosen yoke set screws and nut at top of motor
housing. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod. [Refer to
diagram 2.]
Determine the length of downrod you wish to
use. Thread safety cable and electrical wires
through threaded end of downrod and pull
extra wire slack from the upper end of the
downrod. [Refer to diagram 2.]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align with
holes in yoke--make sure wires do not get twisted.
Re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely. [Refer to diagram 2.]
Slide yoke cover, canopy cover and canopy over
downrod. [Refer to diagram 3.] (Note: Canopy
cover must be turned with shiny side toward the
motor housing.)
Thread safety cable and wires through hanging
ball; then slide hanging ball over downrod--the
top of the downrod should be noted as having a
set screw hole; use this hole when setting the set
screw. Insert stop pin into top of downrod and
raise hanging ball. Be sure stop pin aligns with
slots on the inside of the hanging ball. Tighten
set screw securely. [Refer to diagram 4.]
WARNING: Failure to tighten set screw (on
hanging ball) completely could result in the
fan becoming loose and possibly falling.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common sense
and caution are necessary factors in the installation
and operation of this fan.
set screw
clip
diagram 1
electrical wiring
downrod
clip
diagram 2
electrical wiring
canopy
yoke cover
diagram 3
stop pin
diagram 4
page 5
stop pin
hanging ball
pin
safety cable
yoke set screw
and nut
pin
motor
housing
downrod
canopy cover
motor
housing
set screw hole
hanging ball