Tools And Materials; Before You Begin - KALLISTA P30901-00 Guia De Instalacion

Thank You For Choosing Kallista
We appreciate your commitment to Kallista quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems, please don't
hesitate to contact us. Our phone numbers and website are listed on
the back cover. Thanks again for choosing Kallista.

Tools and Materials

Level Pencil
Assorted
Screwdrivers
Assorted woodworking tools may
be needed to finish the wall.

Before You Begin

DANGER: Risk of personal injury. These products are not
designed or intended for use as a grab bar or support bar. Do
not install any of these products in any area where they are
likely to be used inadvertently as a grab bar or support bar.
IMPORTANT! Do not overtighten the setscrew(s). Overtightening
can damage the accessory.
These products should be located and mounted to a wall stud.
While it is possible to mount them to any surface, a stud
mounted product will yield the best results.
Use a level to ensure that the center lines for the wall plates are
vertical where applicable and the post center lines are horizontal
where applicable.
Kallista reserves the right to make revisions in the design of
products without notice, as specified in the Price Book.
1008325-2-A
Measuring Tape
Plus:
• Assorted Drill Bits
Drill
Assorted Hex
Wrenches
2
Claw
Hammer
Kallista