KALLISTA P30901-00 Guia De Instalacion página 5

Install the Anchors
Nail
2. Install the Anchors
NOTE: You may need to disassemble some of the accessories. Some
accessories will be packed with the wall plate installed in the post.
Loosen the setscrew and remove the wall plate if needed.
Press and hold the legs of a wall anchor together, then insert the
wall anchor legs into the hole. Insert all wall anchors into the
pre-drilled mounting holes.
Carefully tap each wall anchor into the finished surface until
flush.
NOTE: If the wall anchor was inserted into a space between the
studs, it will be necessary to spread the wall anchor legs. Insert a
thin, long object (such as a finishing nail) into the wall anchor hole
to spread the anchor legs.
3. Install the Wall Plate
Horizontally align the mounting holes on the wall plate with the
installed anchors, as shown.
Secure the wall plate with the supplied screws.
Repeat this procedure at each wall plate location.
Kallista
Install the Wall Plate
Anchors
Mounting
Holes
5
Wall
Plate
Screws
1008325-2-A