Replacing Friction Drive Wheel; Disassembly - Generac GC2800B Manual Del Propietário

Maintenance

Replacing Friction Drive Wheel

Disassembly

Proceed as follows to disassemble the friction drive
wheel:
1. Drain fuel and oil from the machine.
2. Shift to 6th gear.
3. See Figure 4-18. With the help of another person,
tip snow blower onto auger housing (A).
Figure 4-18. Tip Unit
4. See Figure 4-19. Insert a flat head screwdriver (B)
into the slot of the wheel retaining clips (C) and
rotate screwdriver away from axle shaft to lift the
inside of the clip above the end of the axle.
B
Figure 4-19. Wheel Retaining Clips Location
22
5. See
6. See
A
011111
7. See
C
011112
Figure 4-20. Push clips off axle shaft (D).
Figure 4-20. Removing Wheel Clips
Figure 4-21. Remove both wheels (E) and
shaft keys (F) from axle shafts (G).
E
F
Figure 4-21. Remove Wheels
Figure 4-22. Use a 10mm wrench to remove
the two bolts (G) securing transmission cover (H),
and remove transmission cover.
H
G
Figure 4-22. Transmission Cover Bolt Locations
Owner's Manual for Snow Blower
D
011113
G
011114
011115