Publicidad
Idiomas disponibles
Idiomas disponibles
(10)Important Safeguards Do not press "M cm" and " " Button at the same time otherwise the
system will enter into Calibration Mode.
Store in a clean, dry place.
■
Use a soft, dry, clean cloth clean the Electronic Torque Adaptor and L.C.D panel.
■
Basic safety precautions should be observed especially when using the Electronic Torque
■
Adaptor on or near children and disabled persons.
Never submerge the Electronic Torque Adaptor in water or any other liquid.
■
Never clean the Electronic Torque Adaptor with organic solvents.
■
Use the Electronic Torque Adaptor only for the intended use described in this manual.
■
Do not exceed the permitted torque value for the Electronic Torque Adaptor.
■
Do not use the Electronic Torque Adaptor if it is not working properly, or if it has suffered
■
any damage.
Do not disassemble the Electronic Torque Adaptor.
■
Do not expose the Electronic Torque Adaptor to extreme temperature, humidity direct
■
sunlight or shock violently.
Do not shake or shock.
■
To ensure accurate measurement periodic reca
■
(11) Torque Range
If the torque range have changed and is not the same as in (02, 03, or 04) product
specifications, may be due to a weak battery.
The battery should be replaced in the case listed in the table.
Item#
Press the button "Mem" and hold them, replace the battery and press the
977
button "Mem" additional for 6 sec.
Press the button "+" and hold them, replace the battery and press the button
978
"+" additional for 6 sec.
Press the button "Power" and hold them, replace the battery and press the
979
button "Power" additional for 6 sec.
Now the original Range is set.
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
Method
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
Publicidad
