Getting Started - Remington Ultimate Serie Manual Del Usuario

PARTS
1. On/off switch
2. Head and cutter assembly
3. Hair pocket
4. LED display
5. Pop-up trimmer
6. Trimmer release button
7. Charging pins
8. Charging stand

GETTING STARTED

CHARGE THE SHAVER:
Note: This shaver is for cordless use only.
1. Ensure the appliance is turned off.
2. Connect the charging stand to the adaptor and then to the mains.
3. Place the shaver in the charging stand.
4. Charge for at least 24 hours when using for the first time.
• Allow 90 minutes for a full charge.
• The LCD display will indicate when the shaver is fully charged.
• When charge is low 'Lo' will appear on the screen and will flash until the shaver is
plugged in to charge. When charging, the LEDs blink in a clockwise rotation. When
fully charged the indicator will flash 60 for 5 minutes and then the display will shut off.
• To preserve the life of your batteries, let them run out every 6 months then recharge
for 24 hours.
• The appliance adapts automatically to a mains voltage between 100V and 240V.
INSTRUCTIONS FOR USE
It is recommended that you use your new shaver daily for up to four weeks to allow time for
your beard and skin to become accustomed to the new shaving system.
SHAVING
1. Switch the shaver on.
2. Stretch the skin with your free hand so the hairs stand upright.
3. Only apply light pressure on the shaving head while shaving (pressing too hard can
damage the heads and make them vulnerable to breakage).
4. Use short, circular strokes.
9. Beard trimming attachment
10. Comb
11. Comb adjustment dial
12. Adaptor (not shown)
13. Headguard (not shown)
14. Cleaning brush (not shown)
15. Storage case (not shown)
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
UA
BG
AE
5