Sanus accents ALT1 Manual De Instrucciones página 11

3
2 ¾ in. (70 mm)
7/32 in.
(5.5 mm)
Drill pilot holes then remove the wall plate template
IMPORTANT:
Be sure to drill into the center of the stud.
IMPORTANT:
Pilot holes must be drilled to a depth of
2 ¾ in. (70 mm), using a 7/32 in. (5.5 mm) diameter drill bit.
06
.
06
4
Install the wall plate using four lag bolts
07
Tighten all lag bolts only until they are pulled firmly against the wall plate.
CAUTION:
Improper use could reduce the holding power of the
lag bolt. DO NOT over-tighten the lag bolts.
Go to STEP 3 on PAGE 19.
07
09
08
and washers
08 09
.
11