Installation - Renaware Aqua Nano UCU LX-200 CAL Uso Y Mantenimiento

Installation

INSTALLING SWAN NECK SPOUT
IMPORTANT: Read all the instructions completely before proceeding. If you
are uncertain about installing this product, we recommend you consult a
professional. This product should be installed in accordance with all local and
state plumbing and building codes.
1. Locate hot water line: If you don't know which one is your hot water line, open
the hot water tap. Wait 30 seconds and feel the two water feed lines under the
sink. The one that is warm is your hot water feed line, the other is your cold water
feed line. Make a note of which is Hot and which is Cold. Also make note which
side each connects to the underside of the existing faucet because the cold water
line will be disconnected later in the installation.
2. Shut off water supply: After locating the water supply inlets, shut off the water
supply valves. These are usually found under the sink or near the water meter. If
you are replacing an existing side faucet, remove the faucet from the sink and
clean the sink surface thoroughly.
3. Tools recommended: PTFE plumber's tape or thread sealant, slotted screwdriver,
pliers, adjustable wrench, flashlight, and cloth. Your installation may require new
supply lines and/or shut-off valves or other additional tools.
8
4. Installing the Side Faucet: NOTE: If there is not already a hole to accommodate
the side faucet, drill one 22 mm (.87") in diameter through the sink deck.
a. Unscrew the nut at the base of the spout. Remove the nut and both the steel and
the rubber washers.
b. Insert the base of the spout through the hole in the sink deck, holding it centered
in the hole with the lights on the Data Collar facing the front of the sink, replace
the Rubber Washer (top) and the Steel Washer and tightening the Brass Retaining
Nut from underneath the sink.
5. Water Supply Connections:
NOTE: The orientation of the valve is only for reference. It may vary according to your
plumbing installation.
a. Disconnect the cold water supply line from the bottom of the existing faucet.
And thread the collar of the 3-way-diverter onto the faucet's Cold Water Inlet.
Line to your exisiting faucet
(Cold Water Inlet)
9