Accessories; Operation; Care/Maintenance; Replacement Indicator Lights - Renaware Aqua Nano UCU LX-200 CAL Uso Y Mantenimiento

Accessories

Stage Zero Filter
In areas where the amount of sediments in the water is very high,
the Pre-Filter cartridge can clog quicker than expected. The Stage
Zero external filter removes the larger particles to prevent this from
happening.
It can be easily back-flushed and replaced to allow your Aqua
system to filter the very small things it was designed to remove and
let you go longer between Pre-Filter back-flushes and NanoCeram®
cartridge replacements.
Mounting Bracket
You may place the entire under-the-counter assembled filter
on a bracket mounted to the wall to raise if off the floor of your
sink cabinet.

Operation

Enjoy freshly filtered water right at your kitchen sink with your Aqua
200 CAL. To turn on, simply move the on/off lever on the Side Faucet down. To turn
off, lift up.
Since the Side Faucet is controlled separately from the main faucet, you may use both
faucets at the same time
Care & Maintenance
Cleaning the AquaNano UCU LX-200 CAL
To clean the exterior of your faucet, filter cartridges, and base unit, use a clean, damp
cloth and mild, non-abrasive liquid soap. Do not use dishwashing soap. Wipe down
with cloth.
Use of polish, detergents, abrasives, cleaners, organic solvents, or acid may cause
damage.
USE OF OTHER THAN A DAMP SOFT CLOTH AND MILD LIQUID SOAP WILL VOID YOUR
WARRANTY.
NOTE: never submerge the unit or let stand in water. Excessive moisture inside the
unit will damage it and void the warranty.
16

Nano

Nano UCU LX-

Replacement Indicator Lights

UCU LX-200 CAL

Your Aqua Nano UCU LX-200 CAL features a visual flow meter integrated into the
base of the spout. When water is flowing through your filter, LED (light emitting
diode) lights will flash to indicate the following:
• The blue light indicates that the unit is functioning normally.
F I LT E R I N G
• The yellow warning light lets you know approximately 1,893 liters
R E O R D E R
(500 gallons) of life is left in the NanoCeram® Cartridge. Contact your Rena Ware
Independent Representative or Rena Ware Customer Service Center to order
a replacement. The blue
F I LT E R I N G
working.
• The red warning light indicates the NanoCeram® Cartridge's effective
R E P L AC E
life has ended. The blue light will not illuminate. Replace the
F I LT E R I N G
NanoCeram® Cartridge before continuing to use your filter.
Non-Functioning Flow Meter
If the electronic flow meter stops functioning, reset the meter by using the following
procedures:
1. Remove the battery compartment door in the bottom of the base by unscrewing
the two screws and by gently prying the door open using a flat screwdriver at the
point shown in the diagram.
2. Remove the old batteries, wait 20 seconds, and then replace with two new high
quality AA batteries.
3. Replace the NanoCeram® filter cartridge.
4. The unit will reset to its default settings.
light also indicates that your filter is still
17