Programming For Cable Box Or Satellite - GE RM24933 Manual De Instrucciones

Programming For Cable Box or
Satellite Receiver
The CBL • SAT button is defaulted to RCA/
GE/ProScan DBS systems, however other
DBS systems can be programmed to this
button.
1. Manually turn on
the Cable Box.
2. Press and hold the
SETUP button until
the INDICATOR LIGHT
lights, then release
the SETUP button.
3. Press and release
the CABLE button
(the INDICATOR
LIGHT will blink
then remain lit).
4. Find the three digit
code for your Cable
Box or Satellite Receiver
in the code list
and enter it using
the Number Buttons.
After your code is
entered, the
INDICATOR LIGHT
will turn off.
5. Aim the remote at
your Cable Box or satellite receiver
and press the ON•OFF button. Your
Cable Box should turn off.
Note: If your Cable Box
does not respond, try all
the codes for your brand.
If the codes do not work,
or your brand is not
listed, try the Code
Search method on
page 8.
6. With your Cable Box
on, press CH+. If the
Cable Box or satellite
receiver responds,
no further program-
ming is required.
7. Enter your code here
for easy reference.
6