LawnMaster GT1313 Manual Del Usuario página 16

MAINTENANCE
WINDING NEW LINE ONTO A SPOOL (See Figs. 15-17)
■ Only use .065" replacement line.
■ You may wind new cutting line onto an empty spool.
■ Replacement packs of cutting line are available from dealer.
■ Remove the empty spool from the grass trimmer as described above.
■ Remove any remaining cutting line from the spool.
■ First feed 4 inches of cutting line
15).
■ Wind the cutting line onto the spool in the direction of the arrow. Make sure to wind the line on neatly and in
layers. Do not criss-cross (Fig. 16).
■ Feed cutting line 6
■ If you want to use, operate as described above to fix the spool on the grass trimmer. Do not forget to
release the cutting lines from the parking slot.
®
Use LawnMaster replacement spool; part NO. RS0101
7
WARNING
Only use the appropriate type of cutting line.
6
into the two eyelets
into the two eyelets 7
6
Fig. 15
7
in the upper section of the spool as shown (Fig.
in the upper section of the spool as shown (Fig. 17).
Fig. 16
16
6
1
Fig. 17