Operation; Cleaning, Servicing - Kenmore 233.5994090 Manual De Uso Y Cuidado / Instalacion

OPERATION

Always turn the downdraft blower on before you begin cooking
to establish an air flow in the kitchen. Let the blower run for a
few minutes to clean the air after you turn the cooktop off. This
will keep the whole kitchen cleaner and brighter.
CONTROLS
Turn the downdraft blower ON by pressing down on the activat-
ing switch. The air vent will rise.
The blower can be turned ON or OFF and its speed can be
adjusted with the recessed knob on the right side of the air vent.
Turn the downdraft blower OFF by pressing the activating switch
again. The air vent will go down and the blower will shut OFF.
NOTE
For most convenient operation, set the blower to your
favorite speed. The blower will come on to this speed
whenever the activating switch is pressed and the air
vent rises.
All manuals and user guides at all-guides.com
Use a mild detergent suitable for painted surfaces. DO NOT
USE ABRASIVE CLOTH, STEEL WOOL PADS, OR SCOUR-
ING POWDERS. Vacuum blower to clean. Do not immerse
blower in water.
Wash the 2 aluminum grease filters in a mild detergent solution
or a dishwasher. Remove them from the air vent by grasping
the tab at the top of each filter.
NOTE
The filters are different sizes. Be sure to replace them as
removed (wider one on the left), with tabs UP.
It may be necessary to remove the downdraft blower system from
the cabinet in order to service components such as the blower
motor or air vent mechanism.
Disconnect power to the cooktop and remove it first. Reverse
the steps under "MOUNT THE UNIT" to remove the downdraft
from the cabinet.
3
CLEANING
WARNING: Always disconnect electric power
supply before cleaning unit.
SERVICING
WARNING: Always disconnect electric power
supply before servicing unit.