Beginning Work With The Machine; End Of Operation - diversey TASKI foam generator 2 Manual De Instrucciones

Dosing examples (dosing according to product in-
formation)
TASKI TR 101
1½
3%
• Screw off the tank cover / dosing cup.
• Fill the tank with water.
• Fill the product you have measured
with the tank cover / dosing cup into
the tank.
• Screw the tank cover / dosing cup
back on.
Moisture content of the foam in percent by volume:
Notice:
The switching position of the dosing con-
trol and of the product dosing unit defines
the moisture content of the foam. This in-
fluences the drying time of the carpet.

Beginning work with the machine

Attention:
Always wear slip-resistant shoes and ap-
propriate working clothes when working
with this machine!
Attention:
Start familiarization with the machine by
making your first driving attempts in a free
area.
Cleaning start
5x
10%

End of operation

• Release the operating lever.
• Remove the plug from the mains socket.
Empty foam solution and clean filter/tank
• Insert the plug into the mains socket.
The display lights up.
• Switch on the device by turning the
dosing control in counter-clockwise
direction.
The foam generator is switched on.
• Select the quantity of foam solution
by the dosing control (min./max. 1-4).
Wait for foam to emerge from under
the brush.
• Switch off the device by turning the
dosing control in clockwise direction.
Notice:
Drain water or cleaning solution must be
disposed of in compliance with the nation-
al regulations.
Notice:
When draining the recovery tank, the reg-
ulations of the detergent supplier regard-
ing personal protective equipment must be
observed.
Attention:
Clogged filters can inhibit the supply of de-
tergents and thus lead to surface damage.
• Position a bucket underneath the
drain opening / filter.
Leave the machine stopped in work-
ing position.
• First, open the tank cover / dosing
cup and subsequently the drain
opening / filter.
• Remove the drain opening / filter.
Notice:
Always remove the tank cover / dosing
cup. Otherwise, a vacuum may be gener-
ated, which will prevent the tank from
draining.
EN
37