Getting Started; Installing Dvd Player To Car Seats; Connecting Power; Connecting Audio/Video Cable - Nevir NVR-2721DVD-PXM Manual De Instrucciones

Getting Started

Installing DVD player to Car Seats

1. Strap the provided car pouches over front car seat headrest.
2. Insert two DVD player screens into the pouches.
3. Close the buckle and adjust the belt until it fits tightly around the headrest.

Connecting Power

1. Connect one end of the supplied power cord to the DC OUT jack and VIDEO/AUDIO OUT jack of the main unit.
2. Connect the other end of the supplied power cord to the DC IN jack and VIDEO/AUDIO IN jack of the display.
3. Connect the power:
To connect power from inside a car, connect the supplied car power cord to the DC IN jack of the main unit and to the car
cigarette lighter socket.
To connect power from household power sources: Connect the supplied adaptor
cable to the DC IN jack of the main unit and to the mains socket.
Caution!
Check that the voltage marked on the adapter rating plate matches your local supply.
When you unplug the adaptor, always pull the plug from the mains socket. Never pull the cord.

Connecting Audio/Video Cable

1. Connect the single-connector end of the supplied audio/video cable to the VIDEO/AUDIO IN jack of the main unit.
2. Connect the triple-connector end of the supplied audio/video cable to the corresponding jacks of the TV display.
Note: Match the color of the AV cable with the jacks of TV display. The yellow cable is for the yellow video jack, the red/white cable
is for the red/white audio jacks.

Install Remote Control Batteries

●Refer to the drawing, remove the battery cover by pulling downwards and insert two AAA type batteries
markings inside the battery compartment.
●For the best results, aim the remote towards at the player, receiving window. Stay within 15 feet and angles of 60 degrees or
less.
●Remove batteries during storage or when you are not using the DVD player for a long time.
observing the polarity
8