Param. Ini (Parameter Initialization); Range (Dynamic Range) - Yamaha RX-V1300RDS Manual De Instrucciones

SET MENU
9 PARAM. INI (parameter
initialization)
Use this feature to initialize the parameters for each DSP
program within a DSP program group. When you
initialize a DSP program group, all of the parameter
values within that group revert to their initial settings.
Press the corresponding numeric button for
the DSP program that you want to initialize.
The asterisk (*) next to the program number means
that the parameter values have been changed.
9 PARAM. INI
*
P r e s s
Notes
• You cannot initialize the individual DSP programs within a
group separately.
• The parameter values of the DSP programs do not change if
you initialize a program group that does not have the asterisk
mark (*).
• When "14 MEMORY GUARD" is set to ON (see page 66),
you cannot initialize any program groups.
• Once you initialize a DSP program group, you cannot
automatically revert to the previous parameter settings.
10 LFE LEVEL
This setting is effective only when this unit decodes
Dolby Digital or DTS signals.
Use this feature to adjust the output level of the LFE
(low-frequency effect) channel when playing back a
Dolby Digital or DTS signal. The LFE signal carries the
low-frequency special effect sound which is only added to
certain scenes.
Control range (dB): –20 to 0 for both SPEAKER and
Initial setting:
1
Press d/u to select the item to be adjusted.
≥ S P E A K E R ... ... ... ... ... ... 0 d B
64
0109V1300_56-68_EN-GB.p65
1 2 3 * 4
5 6 7 8
9 * 1 0
N o . K e y
HEADPHONE
0 dB for both SPEAKER and
HEADPHONE
10 LFE LEVEL
H E A D P H O N E ... ... ... ... 0 d B
64
2
Press j / i to adjust the LFE level.
10 LFE LEVEL
≥ S P E A K E R ... ... ... ... - 1 1 d B
H E A D P H O N E ... ... ... ... 0 d B
Note
• Adjust the LFE level according to the capacity of your
subwoofer or headphones.
11 D-RANGE (dynamic range)
Use this feature to adjust the dynamic range. This setting
is effective only when this unit decodes Dolby Digital
signals.
11 D-RANGE
≥ S P : M A X S T D M I N
H P : M A X S T D M I N
Choices: MAX, STD, MIN
Initial setting: MAX (for both speakers and headphones)
MAX
Select the "MAX" setting for feature films.
STD
Select the "STD" (Standard) setting for general use.
MIN
Select the "MIN" setting for listening to sources at
extremely low volume levels.
2002.11.07, 12:09