Publicidad
Parts Enclosed:
A Bracket
2x
IMPORTANT:
Tipping can injure young children. Use of this safety hardware is highly recommended. This safety hardware,
when properly installed, can provide protection against unexpected accidental tipping of furniture due to improper use.
Step 1
Attach a bracket to the wall board with
the 1 1/2" wood screws provided:
It is recommended that you locate a wall stud
behind the furniture unit. If the wall stud is not
used, a suitable "Hollow-Wall Anchor Bolt" (not
provided) should be used in lieu of the wall stud.
Position the wall bracket on the stud about 1"
below the top the furniture piece.
Mark the position for the bracket placement on the
wall and drill a pilot hole into the stud.
Attach the bracket to the back of the furniture with
the 1 1/2" screws provided.
Wall stud
Wallboard
Important:
Warning:
This product is not be a subsitute for proper parental supervision which is the only proper deterrent to prevent
improper use of this unit. The manufacturer assumes no liability for improper installation or excessive loads placed on
the safety straps, bracket or mounting screws. This hardware will not insure against tipping.
N N o o t t e e :
For taller or heavier pieces of furniture, two safety brackets my be installed.
WALL STUD
SAFETY BRACKET INSTRUCTIONS
B Safety strap
2x
Step 2
To attach a bracket to the furniture
frame below to top with the short 3/4"
screws provided:
position to the wall.
Mark the location of the bracket on the back of
the furniture in relation to the previously
mounted wall bracket.
Move the furniture piece away from the wall
mounted bracket and place the other bracket on
the mark position on the back of the furniture
piece.
the back furniture frame.
Caution:
Make sure you do not drill
completely through the back of
Bracket
the furniture.
Attach the bracket to the back of the
furniture with the 3/4" screws provided.
C
1-1/2" Wood screw
2x
Funiture top
15
D 3/4 Wood screw
2x
Step 3
To attach the safety straps:
Thread 2 safety straps through both of the
mounted brackets as shown in the illustration.
Tighten the straps unit snug.
Do not over tighten.
Wallboard
Funiture top
Publicidad
