iSi SodaSiphon Modo De Empleo página 8

Operation
10. Gently press the lever to remove the soda
water. Direct the stream toward the internal
wall of the drinking glass.
NOTE: If necessary, shake the Soda Siphon again
to achieve optimum use.
Cleaning.
NOTE: Please observe the illustrations on
cleaning!
1. Activate the lever until the siphon is
completely empty and there is no pressure
left. Unscrew the head from the siphon.
2. Remove the riser tube and measuring tube
as shown in the illustration.
3. Rinse the product components with clear
potable water (max. 50°C/122°F) only.
NOTE: Never use scouring agents, abrasive
sponges/brushes, or sharp objects to clean the
siphon.
NOTE: Do not put in the dishwasher and do not
wash in boiling water.
Storage.
If the iSi Siphon is not going to be filled again
immediately, leave the components to air dry
in a clean place and store the iSi Siphon in a
dismantled condition with the measuring tube
inserted. For best results, when not in use, do
not store the siphon with the head screwed on.
10
Troubleshooting.
Release the pressure:
Place the siphon upright in a sink and gently
operate the lever until the pressure is gone from
the iSi Siphon. Now the head can be removed
from the bottle. If the pressure will not release,
please contact iSi or your service center.
Soda charger will not puncture.
1. The charger being used is not suitable.
Only use original iSi soda chargers.
2. The charger was inserted backwards.
Insert the iSi soda charger correctly
(see diagram: Instructions for Use).
3. The puncturing unit has been damaged.
Send the siphon to iSi or a service center.
Water does not contain any CO
any at all.
1. The siphon was not shaken enough.
After screwing on the iSi soda charger,
shake the siphon vigorously several
times (at least 5 times).
2. The water is not cold enough.
The colder the water, the more CO
it can absorb. For the best results we
recommend keeping the filled Soda
Siphon in the refrigerator.
3. No pressure/not enough pressure in the
device.
Only use original iSi soda chargers.
Do not reuse empty chargers. They
should be recycled.
4. Gas is leaking between the bottle and
the head.
See "During operation, gas is leaking
between the bottle and the head."
During operation, water and gas are leaking
through the outlet — pressure-relief valve is
engaged.
1. The siphon was overfilled.
"Release the pressure" and refill the
siphon.
or hardly
2
2
11
EN