Maintenance Instructions - Altrad Belle MAXI 140 Manual Del Operador

GB
ELECTRIC MOTORS
All portable electric appliances are dangerous if abused. This machine will only operate on one voltage. Check the power supply to
power supply.
220/240v - Always use a Residual Current Device ("RCD"), (earth leakage trip), plugged directly into the 220/240v socket. If using an
extension cable, plug it directly into the RCD.
110v - When using a portable transformer it must have a minimum output of 3.3kw and be continuously rated.
The symbols on the ON/OFF switch are 0=OFF and I=ON in accordance with international standards.
WARNING
EXTENSION CABLES
If you need to use an extension cable it must be no longer than 30 metres (100 feet) in length. The wire section must be 1.5mm
2
on 230v and 2.5mm on 110v. Ensure that the extension cable is carefully laid out avoiding liquids, sharp edges and places where
vehicles might run over it. Avoid allowing the extension cable to be trapped underneath the mixer. Unroll it fully or it will overheat and
COMBUSTION ENGINES
If the safety facilities are damaged or don't function correctly the mixer must not be used.Be aware of exhaust venting directions, all
exhausts vent to the left hand side of the machine when viewed from the rear of the machine.To maintain correct lubrication the mixer
must always be opened on level ground. Always read the engine manufacturers manual before starting the engine.Ensure plenty of
DRUM (Removal and Fitment)
fork lift, with the forks under the base of the drum. When replacing make sure that the drum shaft is greased before it is fully
screwed down on to the shoulder of the shaft, ensure the drum is fully screwed down on to the shoulder or damage will occur. Take
care when screwing on the drum, spinning on fast may damage the gearbox.
CLEANING
let any liquids near the engine/motor. Use 1" gravel and clean water to clean the inside of the drum. DO NOT use bricks etc. as this
will damage the drum.
DRIVE BELT
- DO NOT try to adjust with the engine / motor running.
- DO NOT run slack.
- DO NOT operate machine with guards removed.
The drive belt is under constant even tension by a spring loaded jockey, this requires no attention. The bearings are sealed for life.
GEARBOX OIL
Note: The original gearbox oil is a synthetic oil and must not be mixed with a mineral oil.
LUBRICATION AND RUNNING
See Maintenance Schedule Section and Operating Instructions.

Maintenance Instructions

DO NOT use an extension cable between the transformer and the power supply. Always ensure that
with cable clip to the mixer frame at all times.
DO NOT
10
2