Pulmic DRAGON 7 POWER Instrucciones Para El Uso página 37

• To recharge the battery proceed as follows:
• Make sure the power supply network tension is the same as reported on the battery charger plate;
• Connect the battery charger with an electric socket being suitable and electrically protected;
• Insert the battery charger plug in the special "C" battery-charger socket placed in the front area at
the lower machine part.
• Lights the pilot lamp, the battery is down.
• Blinks the pilot lamp, the battery is charged.
• To completely recharge the battery, when the latter is totally down, approximately 7 hours are needed.
• Once the charge operation is finished, disconnect the battery charger from the power supply
network and after that from the machine.
The battery life mostly depends upon some basic rules:
• Do not short-circuit the battery;
• Promptly recharge the battery in a due time;
• To recharge only use the battery charger supplied with. In no case, a battery charger different from
the supplied one shall be used;
• Never operate the machine when the battery charger is connected;
• The battery shall be recharged and kept at a temperature between 5 and 40° C;
• In case of a long period of storage/standstill, the battery shall be recharged every four months. A
non-recharge of the battery for a period exceeding four months could cause its irreversible wear with
a consequent, premature battery replacement;
• When the battery cannot be recharged, at all, it shall be replaced through a battery having the same
features and dimensions and at the same time, the polarity of the connections shall be followed; to
dispose of batteries, turn to an authorized point of disposal.
6.3 BATTERY REPLACEMENT AND RECHARGE OUTSIDE OF THE MACHINE
• Following the page 6 instructions, it is possible to extract the battery from the bottom of the
machine and replace it with a new battery.
• For the replacement operations, please follow the numbered steps on page 6 in the correct sequence.
• The machine will be completely empty and switched off before the replacement operation.
• The second battery is optional.
7. TROUBLESHOOTING
TROUBLES
Notwithstanding the
machine is properly
operated, no dust delivery
occurs
PROBABLE CAUSES
The motor does not
function
The motor functions
The fuse is burnt-out
The battery is exhausted
or down
The fan is jammed
The electric cable is discon-
nected
The microswitch is not
working
The electric motor is out of
order
The switch is not working
The conduits are clogged
The measuring device is
clogged
The measuring device is
broken
37
SOLUTION
Replace the fuse
Replace or recharge
the battery
Replace the fan
Replace or repair the cable
Replace the microswitch
Replace the motor
Replace the switch
Clean the conduits
Clean the measuring
device
Replace the measuring
device