sunjoe SWJ806E Manual Del Operador página 4

4. To prevent the appliance cord from disconnecting from the
extension cord during operation, make a knot with the two
cords as shown in Table 1.
Table 1. Method of Securing Extension Cord
Cord set
(A) Tie cord as shown
(B) Connect plug and receptacle
5. Do not abuse the cord. Never pull the electric pole + chain
saw by the cord or yank the cord to disconnect it from the
receptacle. Keep the cord away from heat, oil, and
sharp edges.
Kickback
m
WARNING!
Kickback may occur when the nose or tip of
the guide bar touches an object, or when the wood closes in
and pinches the saw chain in the cut.
AVOID CONTACTING THE GUIDE BAR TIP WITH ANY
OBJECT. In some cases, when the tip makes contact with an
object, it may cause a fast reverse reaction, kicking the guide
bar up and back towards the operator. Pinching the saw chain
along the top of the guide bar may also push the guide bar
rapidly back towards the operator. Either of these reactions
may cause you to lose control of the saw, which could result in
serious personal injury.
• When using as a pole chain saw, always use two hands
when operating the pole chain saw, one hand gripping the
trigger and the other hand gripping the pole. Use a firm
grip. Thumbs and fingers must wrap around the trigger
and the pole. When using as a chain saw, maintain a
firm grip (right hand on the rear handle and left hand on
the front handle with thumbs and fingers encircling the
Appliance cord
KICKBACK
DANGER ZONE
4
respective handles) and position your body and arms to
allow you to resist kickback forces. Kickback forces can
be controlled by the operator if proper precautions are
taken. Do not let go of the chain saw.
• Keep all guards in place on the machine. Make sure they
are in proper working order.
• Do not overreach. Do not extend arms above shoulder
height when using as a pole chain saw or cut above
shoulder height when using as a chain saw. This helps
prevent unintended tip contact and enables better control
of the unit in unexpected situations.
• Keep solid footing and balance at all times.
• Never try cutting through two branches at the same time.
Only cut one at a time.
• Do not bury the guide bar nose or try to cut by boring the
guide bar nose into the wood.
• Watch for shifting of wood or other forces that may pinch
the chain.
• Use extreme caution when re-entering a previous cut.
• Use the low-kickback chain and guide bar supplied with
this electric pole + chain saw. Only use genuine
Snow Joe + Sun Joe
® ®
specifically for use with this electric pole + chain saw.
• Never use a dull or loose chain. Keep the chain sharp and
properly tensioned.
• Follow the manufacturer's sharpening and maintenance
instructions for the saw chain. Decreasing the depth
gauge height can lead to increased kickback.
• Always observe the safety regulations and follow the
correct sawing techniques.
• Ensure safe carrying of the unit. Whenever the machine is
to be handled or transported, you must:
– Switch off the motor and wait for the chain to come to
a complete stop;
– Mount the guide bar cover;
– Hold the machine using the hand grips and
position the bar in the opposite direction to that used
during operation.
When using a vehicle to transport the machine, fasten the
tool firmly and position it so that it is not a danger to any
passengers.
• Before cutting, pruning, or delimbing for the first time,
make sure:
– You have been specifically trained to use this type
of equipment;
– You have carefully read the safety regulations and
user instructions contained in this manual;
– You practice first on logs on the ground or attached
to trestles/saw horses, in order to get familiar with the
machine and the proper cutting techniques.
replacement parts designed