Carton Contents - sunjoe SWJ806E Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Unpacking

Carton Contents

• Electric chain saw
• Telescoping pole
• 8 in. (20.3 cm) guide bar
• 8 in. (20.3 cm) cutting chain
• Hex key wrench/blade screwdriver
• Extension cord restraint hook
• Cutting bar sheath
• Manual with registration card
1. Carefully remove the electric pole + chain saw and check
to see that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe
+ Sun Joe
®
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use your new electric pole +
chain saw. The packaging is made of recyclable materials.
Properly dispose of these materials in accordance with
local regulations.
IMPORTANT! The equipment and packaging material are
not toys. Do not let children play with plastic bags, foils,
or small parts. These items can be swallowed and pose a
suffocation risk!
Assembly
m
WARNING!
Always wear heavy-duty gloves when
handling the bar and chain. Mount the bar and chain very
carefully so as not to impair the safety and efficiency of the
machine. If in doubt, contact an authorized Snow Joe
Sun Joe
dealer or call the Snow Joe
®
service center at 1-866-SNOWJOE (1-866-766-9563).
m
WARNING!
Unpacking and assembly should be
completed on a flat and stable surface, with adequate space
for moving the machine and its packaging.
m
DANGER!
Never start the motor before installing the
guide bar, chain, and chain cover. Without all these parts in
place, the clutch can fly off or explode, exposing the user to
potentially serious injuries.
m
WARNING!
To avoid serious personal injury, read and
understand all safety instructions provided.
customer service center at
®
+
®
+ Sun Joe
customer
®
®
m
WARNING!
Before performing any maintenance, make
sure the tool is unplugged from the power supply. Failure to
heed this warning could result in serious personal injury.
Installing/Replacing the
Guide Bar and Chain
Tools and supplies required:
• Dual-tipped hex key wrench/blade screwdriver (supplied)
• Heavy-duty work gloves
NOTE: When replacing the guide bar and chain, use only
identical replacement parts. Make sure the electric pole +
chain saw is disconnected from the power supply before
proceeding with installation.
1. Using the supplied hex key wrench, unscrew the end
cover nut and remove the chain/sprocket end cover
(Figs. 1 & 2).
Fig. 1
Fig. 2
2. Remove the cutting bar and chain from the mounting
surface (Fig. 3).
7
End cover nut
R
Hex key wrench
R
Chain/sprocket end
cover

Publicidad

Tabla de contenido
loading

Tabla de contenido