Routine Maintenance - Amano American Sanders FloorCrafter Manual Del Operador

EN
The following items need to be periodically inspected and maintained to keep your sander in good working condition.
Sanding Chamber
Periodically blow out the sanding chamber to prevent large accumulations of debris which could interfere with the performance of the tension roller.
NOTE: The tension lever should be in the run/tight abrasive position to blow out.
Wheels
Periodically remove the debris from the truck and caster wheels. Debris can cause waves on a sanded surface.
Dust Bag
Remove the dust bag from the machine and shake it thoroughly to remove the sanding dust from the dust bag. Turn the dust bag inside out and
machine wash in cold water to prevent pore blockage and loss of dust recovery.
Drive Belt
Drive belt tension is factory set and should not require adjustment. Periodically check the drive belt tension. Proper belt tension is achieved when
5 lbs. of force at the mid-span of the belt produces ½ inch of deflection.
To increase belt tension, release tension using quick release lever (See Figure 6).
Turn the adjustment screw "OUT" (See Figure 21) one quarter turn. Restore
tension using quick release lever and check adjustment. Repeat this process
if necessary. To lower tension, the adjustment screw is turned "IN".
Bearings
Periodically check the bearings for wear or damage according to the
following schedule:
after 1
Guide rollers
after 1
Idler pulley
after 1
Fan shaft
Tension roller after 1
Arbor shaft after 1
after 1
Motor shaft
Rollers
Periodically check the guide rollers and the tension roller for wear.

Routine Maintenance

650 hrs.
st
1500 hrs.
st
2500 hrs.
st
2500 hrs.
st
5000 hrs.
st
5000 hrs.
st
16
Figure 21