Empire EBL74 El Manual Del Propietario página 15

Operation
• Indicated by the
the intake temperature be-
ing displayed on the Floating
Display , for 5 seconds before
TM
turning off.
! NOTE: After the heater is
switched off, there is a 60 sec-
ond fan delay, where the fan
will continue running before
turning off.
! NOTE: The unit can be
operated in Heat Only Mode.
When the unit is only running
with the heater, the
continuously be displayed on
the Floating Display
! NOTE: The heater may emit
a slight, harmless odor when
first used. This odor is a nor-
mal condition caused by initial
heating of internal heater parts
and will not occur again.
D & E. Thermostat Controls
Adjusts the temperature set point
to your individual requirements.
Once the desired set temperature
is reached the heater will turn off.
The heater will cycle on and off
to maintain the desired set tem-
perature. The default temperature
setting is 72°F (22°C).
→ Adjusted by pressing the
icon and
icon will
.
TM
to decrease the setpoint and
the to increase the setpoint
on the unit or the remote.
• The Floating Display
dicate the temperature setpoint
as it is adjusted.
! NOTE: Holding the
the buttons down for
two seconds, on the unit, will
change the temperature from
°C to °F, or vice versa.
Disable Heat
If desired, depending on the sea-
son, the heater on the unit can be
disabled. The unit will operate in
the same fashion, with remainder
of the controls.
Pressing the
on the unit at the same time and
holding for 2 seconds will disable
and enable the heater.
! NOTE: When the heater has
been disabled and either the
or the
Floating DisplayTM will indi-
cate "--".
F. Color Themes
Different presets of ambient light-
ing color combinations contained
in the unit.
will in-
TM
and
and buttons
is pressed the
15