Cooper Lighting HALO Commercial HC8R Instrucciones De Instalación página 5

5. Retrofit ring can be adapted to various ceiling
thicknesses and plaster frame/housing heights by using
different slot locations for mounting springs. HC8R/
HC812R ships with springs in upper position for a
combined ceiling and housing thickness greater than
1" and no more than 2" . For ceiling/housing thicknesses
between 0.5" and 1" mounting springs should be
moved to lower position (Figure 31).
6. To prevent movement in the housing/ceiling opening
use a flat head screw driver to pry out 4 centering tabs
on Retrofit Ring Assembly (Figure 32.).
Upper Position
Lower Position
Figure 31.
Figure 32.
7 . When Retrofit Ring is first installed into ceiling, four
safety brackets will prevent the LED Module from
being installed (Figure 33). To continue with installation
turn the free arm of the safety brackets clockwise until
the arm makes a 90° angle with the fixed base of the
safety bracket (Figure 34).
Safety Brackets
Figure 33.
Installation Instructions – HC8R/HC812R Recessed LED Retrofit
Safety Brackets
Figure 34.
Reflector and LED Module
1. 1. Place end of flexible conduit through frame opening
in ceiling exposing upper portion of quick disconnect
(Figure 35).
Luminaire Quick
Disconnect
LED Engine
Trim Assembly
Figure 35.
2. Remove LED engine from protective packaging.
3. Remove trim assembly from protective packaging and
rotate side clips (3) outwards. (Figure 36).
Figure 36.
COOPER LIGHTING SOLUTIONS
Torsion Springs
IB517033ML
Installation instructions
Side Clips
5