Wiring - Litex Industries E-AVA52BNK5CR Guia De Instalacion

5. Fan Assembly. (cont.)
With the hanging bracket secured to the outlet box
and able to support the fan, you are now ready to
hang your fan. Grab the fan firmly with two hands.
Slide downrod through opening in hanging bracket
and let hanging ball rest on the hanging bracket.
Turn the hanging ball slot until it lines up with the
hanging bracket tab.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.

6. Wiring.

Important: Be sure outlet box is properly
grounded and that a ground wire (GREEN or Bare)
is present.
Use a ballpoint pen or a small screwdriver to set
the code switches for the remote control
transmitter and receiver (located inside top of
motor housing) so that they match. (Refer to
diagram 1.) Factory setting is all on and not
recommended for use. If your remote control
interferes with other appliances, change to
another code on the remote control transmitter
and receiver.
In order for the remote control to operate, one 9-
volt battery (sold separately) should be installed
in the remote control transmitter. Re-attach the
battery cover after installing the battery. (Refer
to diagram 1.)
Connect BLACK and wire from fan to BLACK
wire from ceiling with wire connector.
Connect WHITE wire from fan to WHITE wire
from ceiling with wire connector.
Connect all GROUND (GREEN) wires together
from fan to BARE/GREEN wire from ceiling with
wire connector. (Refer to diagram 2.)
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently push taped wire connectors into outlet
box.
remote control
transmitter
battery
battery cover
diagram 1
white supply wire
black supply wire
from ceiling
black
white
white
black
from fan
diagram 2
page 5
hanging bracket tab
hanging ball slot
code switches
motor housing
(top view)
ground
(green or bare)
ground
(green
or bare)
*