Preparation For Wiring; Wiring - Litex Industries BRC52BNK5 Guia De Instalacion

5. Preparation for Wiring.

Remove 4 motor mounting screws and lock
washers from the bar on the top of motor
assembly; leave rubber cushions in place. Lift
motor assembly to hanging bracket and place
one end of motor assembly in hanging bracket
slot. This will allow motor assembly to hang out
of the way while wiring.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.

6. Wiring.

NOTE: See instructions above (Section 5) in order
to temporarily hang fan on hanging bracket
during wiring.
CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the instructions
below, please use a qualified electrician.
When fan is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect BLACK wire from fan to BLACK wire
from ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire
from ceiling with wire connector provided.
Connect all GROUND (GREEN) wires from fan
together to BARE/GREEN wire from ceiling with
wire connector provided.
Since this fan does not come with a light kit, you
will need to cap off the BLUE wire with a wire
connector (as shown with arrow in diagram).
[Note: If you elect to purchase a light kit for the
fan, the BLUE wire from the fan must be
connected to the BLACK wire from the ceiling
instead.]
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
hanging
bracket
motor
mounting
screws and
lock washer
BLACK
WHITE
WHITE
BLACK
hanging BLUE
bracket
page 4
motor assembly
GROUND (GREEN OR BARE)
GREEN
*
motor assembly
hanging
bracket slot
GREEN