Troubleshooting - LEXIBOOK MeteoClock Fruity Manual De Instrucciones

SM940IM size : 120mm W x 120mm H
REMARKS:
• After having completed the settings of your weather station, please discard the readings of the weather
forecast for the next 12-24 hours. This will allow sufficient time for the Weather Station to operate at a
constant altitude and therefore result in a more accurate forecast.
• Absolute accuracy cannot be guaranteed regarding weather forecasting. The weather forecasting feature is
estimated to have an accuracy level of about 75% due to the varying areas the Weather Station has been
designed to be used in.
• If the Weather Station is moved to another location significantly higher or lower than its initial standing point
(e.g. from ground floor to 1st floor of a house), remove the batteries and reinsert them after about 30
seconds. By doing this, the Weather Station will mistakenly consider the new location as a possible change
in air pressure. Again, discard the weather forecasts for the next 12-24 hours as to allow time for operation
at a constant altitude.

TROUBLESHOOTING

Problem:
1. The main unit cannot receive radio control DCF-77 or MSF signals to update the clock.
2. The temperature measurements of the remote sensor and receiver do not match.
3. Temperature reading of outdoor remote sensor seems too high.
4. Receiver is no longer receiving remote sensor signals or display.
5. An abnormal operation has been observed and certain functions do not work.
Solution:
1. Place the clock away from metal objects or electrical appliances such as TVs, computers, monitors, etc.
Trigger the scan manually by holding the Minute/- key [3] for 3 seconds.
2. Wait a few minutes to ensure the remote sensor and receiver are in phase. Otherwise, re-synchronize
receiver by holding CHN [10] for 3 seconds until a beep is heard.
3. Ensure the remote sensor is out of direct sunlight, and away from sources of heat.
4. Repeat the learning procedures.
- Temperature may be below -30°C.
- Batteries in remote sensor may need changing.
- Move remote sensor closer to the receiver.
- Make sure remote sensor is away from sources of electrical disturbance.
5. Reset the unit by replacing the batteries in both the transmitters and receiver.
Additional sensors:
Measure temperature and hygrometry in other places!
- Upstairs
- In the baby's bedroom
- In the basement
- In the garden
- In another room
To order, phone the Lexibook office located in your country or browse www.lexibook.com.
Weather Station Receiver SM940
Battery Type:
Temp.Range:
Measurement Accuracy:
Resolution:
Humidity Range:
Measurement Accuracy:
Resolution:
Weather Station Transmitter ASM5
Battery Type:
Temp. Range:
Humidity Range:
Transmission Frequency:
Transmission Range:
25 26
ACCESSORIES
SPECIFICATIONS
2 X1.5V AA batteries
-20 C to +55 C
+/- 1.5 C Within measuring range of 0 to 0C
0.1 C
15% to 95%
+/- 5%
1%
2 X1.5V AAA batteries
-30 C to + 70 C
15% to 95%
433.92MHz
Up to 40 meters in open area.