Empire EBL50 El Manual Del Propietario página 18

Operation
C. Heat ON/OFF
Turns the heater On and Off.
→ Activated by pressing the
button on the unit or the
remote.
• Indicated by the
the intake temperature being
displayed on the On-Screen
Display, for 5 seconds before
turning off.
! NOTE: After the heater is
switched off, there is a 60
second fan delay, where the
fan will continue running before
turning off.
! NOTE: The unit can be
operated in Heat Only Mode.
When the unit is only running
with the heater, the
continuously be displayed on
the On-Screen Display.
! NOTE: The heater may emit
a slight, harmless odor when
first used. This odor is a normal
condition caused by initial
heating of internal heater parts
and will not occur again.
18
icon and
icon will
D & E. Thermostat
Controls
Adjusts the temperature set point
to your individual requirements.
Once the desired set temperature
is reached the heater will turn
off. The heater will cycle on
and off to maintain the desired
set temperature. The default
temperature setting is 72°F
(22°C).
→ Adjusted by pressing the
decrease the setpoint and the
to increase the setpoint on
the unit or the remote.
• The On Screen Display will
indicate the temperature
setpoint as it is adjusted.
! NOTE: Holding the
the buttons down for two
seconds, on the unit, will
change the temperature from
°C to °F, or vice versa.
Disable Heat
If desired, depending on the
season, the heater on the unit
can be disabled. The unit will
operate in the same fashion, with
remainder of the controls.
Pressing the
and
and buttons
www.empirecomfort.com
to