Product Data Sheets; Application Guidelines/Water Supply Parameters - KitchenAid KUDR204KSB Guia De Uso Y Cuidado E Instrucciones De Instalacion

Base Grille Water Filtration System
Model WF-L200V capacity 200 gallons (757 liters)
Model WF-NL120V capacity 120 gallons (454 liters)
This system has been tested according to ANSI/NSF 42/53 for the reduction of the substances listed below. The concentration of
the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit
for water leaving the system, as specified in ANSI/NSF 42/53.
Substance
NSF Reduction
Reduction Aesthetic
Effects
Chlorine Taste/Odor
Particulate Class
III*
Contaminant NSF Reduction Average Influent Challenge Maximum Average Minimum % Average % Reduction Requirements
Influent Concentration Effluent Effluent Reduction Reduction.
Contaminant NSF Reduction
Reduction
Lead: @ pH 6.5
Lead: @ pH 8.5
Mercury: @ pH 6.5
Mercury: @ pH 8.5
Benzene
p-dichlorobenzene
Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa).
Temp. = 63 °F (17.2 °C).

Application Guidelines/Water Supply Parameters

It is essential that operational, maintenance, and fi lter
replacement requirements be carried out for the product to
perform as advertised.
Model WF-L200V: The fi lter monitor system measures the
amount of water that passes through the fi lter and alerts
you to replace the fi lter. When 90 % of the fi lter's rated life is
used, the fi lter indicator light changes from green to yellow.
When 100 % of the fi lter's rated life is used, the fi lter indicator
light changes from yellow to red, and it is recommended
that you replace the fi lter. Use replacement cartridge L200V
/ NL120V, part #4396702. 2014 suggested retail price of
$32.99 U.S.A./ $49.99 Canada. Prices are subject to change
without notice.
Model WF-NL120V: Change the water fi lter cartridge every
6-9 months. Use replacement cartridge L200V / NL120V,
part #4396702. 2014 suggested retail price of $32.99 U.S.A./
$49.99 Canada. Prices are subject to change without notice.
Class III particle size: >5 to <15 um
**Test requirement is at least 10,000 particles/mL of AC Fine Test Dust.
***These contaminants are not necessarily in your water supply. Performance may vary based on local water conditions.
®NSF is a registered trademark of NSF International.
05-May-2021 10:43:59 EDT | RELEASED

PRODUCT DATA SHEETS

Average
Requirements Infl uent
≥ 50 % 1.9 mg/L
≥ 85 % 49,333/mL
Average
Requirements Infl uent
0.01 mg/L 0.14 mg/L***
0.01 mg/L 0.15 mg/L***
0.002 mg/L 0.0059 mg/L
0.002 mg/L 0.0054 mg/L
0.0050 mg/L 0.0157 mg/L
0.075 mg/L 0.210 mg/L
In some European factories the letter "W" of the part code mentioned herein will be automatically
Tested and certified by NSF International against
ANSI/NSF Standard 42 for the reduction of Chlorine,
Taste and Odor, Particulate Class lll*; and against
ANSI/NSF Standard 53 for the reduction of Lead,
Mercury, Benzene, and p-dichlorobenzene.
Infl uent
Maximum
Challenge
Effluent
Concentration
2.0 mg/L ± 10 %
0.07 mg/L
At least 10,000
640 mg/L**
particles/mL
Infl uent
Maximum
Challenge
Effluent
Concentration
0.15 mg/L ± 10 % 0.0014 mg/L
0.15 mg/L ± 10 % 0.0069 mg/L
0.006 mg/L ± 10 % 0.0009 mg/L
0.006 mg/L ± 10 % 0.0007 mg/L
0.015 ± 10 % 0.002 mg/L
0.225 ± 10 % 0.0005 mg/L
The product is for cold water use only.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system.
Refer to the front cover or "Accessories" section for the
Manufacturer's name, address and telephone number.
Refer to the "Warranty" section for the Manufacturer's limited
warranty.
Water Supply
Water Pressure
Water Temperature
Service Flow Rate
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
Average Minimum %
Effluent Reduction
0.06 mg/L >75.0 %
312 mg/L 98.7 %
Average Minimum %
Effluent Reduction
0.0011 mg/L 99.0 %
0.0042 mg/L 95.4 %
0.0004 mg/L 84.74 %
0.00043 mg/L 87.03 %
0.00083 mg/L 87.26 %
0.0005 mg/L 99.76 %
City or Well
30 - 120 psi (207 - 827 kPa)
33 °F - 100 °F (0.6 °C - 37.8 °C)
0.5 GPM (1.89 L/min.) @ 60 psi. (413.7 kPa)
Average %
Reduction
>75.0 %
99 %
Average %
Reduction
99.21 %
97.08 %
92.47 %
91.93 %
87.26 %
99.76 %
17